~100 drills in ~100M2 - material change from PRE?, page-53

Hi TM - Thanks for your comments
The announcement I was referring to was dated 10 August 2010.
Here is the link - http://www.asx.com.au/asx/statistics/displayAnnouncement.do?display=pdf&idsId=01085189

The key hole in the old announcement (GTD007) intersected 69m @ 6.80g/t.

In summary two new holes have been drilled 10m either side of the old hole as follows:

New hole GTRC382 6,838,290mN 357,535mE 40m @ 4.35g/t 96m final depth
Old hole GTD007 6,838,280mN 357,533mE 69m @ 6.80g/t 140m final depth
New hole GTRC386 6,838,270mN 357,530mE 65m @ 4.46g/t 138m final depth

All holes old and new where drilled at -60 degrees towards the west (270).

Looking at the collar plan in Monday's announcement (and based on the co-ordinates above) the old hole GTD007 should sit in an almost straight line between GTRC382 and GTRC386. However, to me it looks as though the old (and significant) diamond drill hole was not even plotted on this plan only the RC holes that can be correlated to those shown on the old ASX release cross section.